Printable Conduit Bending Chart. Learn the basics, types of conduits, tools required, and for efficient and accurate bending. 4 bend conduit until contact with the angle setter™ is felt.
To make a 90° bend with a 4” center line radius: Web the following illustrations and instructions show the most common bends. Even the “multiplier” and “deduct” figures are usually stamped onto the bender device.
Mark The Conduit 203.2Mm From The End.
Even the “multiplier” and “deduct” figures are usually stamped onto the bender device. Find the chart that corresponds to the size of conduit selected in step 1. Line up the arrow on the bender with the mark on the.
Review The Bracket Decals To Locate The Correct Side Of The Frame To Use.
Stubs height y mark angle 1. For more information on using a hand bender, see my comprehensive guide to bending conduit. Radius and deduct figures for conduit size of conduit radius of bend deduct for 90 degrees 1/2 4 5 3/4 4 1/2 6 1 5 3/4 8 multipliers for conduit offsets degree of bend multiplier 10 degrees 6.0 22 degrees 2.6 30 degrees 2.0 45.
To Be Used With Stub, Offset And Outer Marks Of Saddle Bends.
Locates the center of a saddle bend. 30° bend with a 6” offset depth. Determine the height of stub and the angle of bend.
Stubs Height Y Mark Angle 1.
Your ideal bender has engineered features which include: Will work for floor and air bends. The resting condition of the conduit is to be at the final angle desired.
Web For More Information On Using A Hand Bender, See My Comprehensive Guide To Bending Conduit.
Line of sight apply foot pressure here. Web install bender bracket on opposite conduit “b” and directly across from the chain crank unit, and tighten screws temporarily. Web the following illustrations and instructions show the most common bends.